What does this screen solve?
Ordering material for a roof from the plans. You have the footprint, the overhang and the pitch. Sloped area, squares, sheathing and bundles are four multiplications away, and this screen does all four at once.
What goes in, and what comes out?
Inputs
- Gable or Hip
- Length and Width in feet, typed as decimals (40’ 6” is 40.5)
- Eave overhang in inches, applied to all four sides
- Pitch: chips from 1:12 to 18:12
- Sheathing waste in percent (blank = 10)
Outputs
- Roof area, sq ft
- Squares
- 4×8 sheathing, sheets
- Shingle bundles
- Pitch multiplier, slope angle, plan area (incl. overhang) and sheathing waste applied
The formula sits under the result: multiplier = √(rise² + 144) ÷ 12, 3 bundles per square (3-tab asphalt). Share sends roof area, squares, sheets and bundles as text.
Worked example: 40’ × 28’, 6:12
Gable, 12” overhang all around, 10% sheathing waste.
- Plan area: (40 + 2) × (28 + 2) = 42 × 30 = 1260 sq ft
- Pitch multiplier: √(36 + 144) ÷ 12 = √180 ÷ 12 = 1.1180
- Slope angle: atan(6 ÷ 12) = 26.6°
- Roof area: 1260 × 1.1180 = 1408.7 → 1409 sq ft, 14.09 squares
- Sheathing: 1408.7 × 1.10 ÷ 32 = 48.4 → 49 sheets
- Bundles: 14.09 × 3 = 42.3 → 43 bundles
Sheets and bundles always round up. Nobody returns 0.4 of a bundle.
Why do gable and hip give the same area?
Same footprint, same pitch, same sloped area. A hip spreads it across four planes instead of two, and the multiplier applies to every plane equally. Flip the toggle and the number doesn’t move.
What changes is the waste. The app’s note: a hip needs extra cap shingles and generates more cutting waste. Raise the sheathing waste for a hip and add cap shingles to the order yourself.
Where does the pitch come from?
The chips cover whole pitches from 1:12 to 18:12 (a 7½:12 roof gets rounded to a chip by you, not the app). On an existing roof, lay the phone on the deck with the Pitch Meter and pick the nearest chip.
The free roof pitch calculator on this site converts rise and run to degrees and a rafter multiplier in the browser. Use it when the angle is all you need. Use the app when you need the material count, offline, on the roof.
What doesn’t it cover?
Waste hits sheathing only. Bundles are squares × 3, rounded up, with no waste added. Starter, ridge and hip cap aren’t in the 43.
3 bundles per square is the 3-tab assumption. Check the coverage printed on the wrapper of what you’re actually buying.
Rectangular planes only. The app’s note says dormers and valleys are not included. Run a dormer separately and add it.
One overhang for all four sides. A 16” eave with an 8” rake goes in as one number (the app doesn’t split them, so pick the larger and accept a few extra square feet, or adjust by hand).
4×8 sheets only. Sheathing is roof area × (1 + waste) ÷ 32.
The app’s note opens with “Estimate only” and says to verify against your supplier’s coverage before ordering. I’d do the same.