What does this screen solve?
Any right triangle on the job: rafter rise and run, a stair stringer, a brace, the diagonal that squares a deck frame. Two sides in, the third side plus pitch, angle and grade out. No trig on a phone calculator, no flipping through a framing square table.
It sits on the Calculator tab, next to the Feet-Inch calculator.
What goes in?
A segmented control picks which two sides you know:
- Rise-Run
- Rise-Diagonal
- Run-Diagonal
Two fields, labeled in inches: Rise, Run or Diagonal. Both values have to be greater than zero. Results update as you type.
What comes out?
A drawing of the triangle, then a result card with six rows:
- Rise, Run, Diagonal: in whatever format the pill is set to (ft-in to the nearest 1/16”, in, dec ft, dec in, metric)
- Pitch: X:12, whole number or one decimal (7:12, 7.5:12)
- Angle: degrees to two decimals, measured at the base, opposite the rise
- Grade: percent to one decimal
Long-press any row to copy the value. Under the card: Save to a project, Share as text, and → Rafter.
Worked example: rise 7”, run 12”
Rise-Run mode, 7 and 12.
- Diagonal: √(7² + 12²) = √193 = 13.892”. To the nearest 1/16” (13.892 × 16 = 222.3, so 222/16) that’s 13-7/8”, which ft-in format shows as 1’ 1-7/8”.
- Pitch: 7 ÷ 12 × 12 = 7:12
- Angle: atan(7 ÷ 12) = 30.26°
- Grade: 7 ÷ 12 × 100 = 58.3%
With a 12” run, the diagonal is the rafter length per foot of run. 13.89” for a 7:12.
Where does → Rafter go?
It queues the result for the Rafters screen (Pro). Open Rafters and the pitch is already filled in from your rise and run. Useful when you worked out the slope here and want line length, plumb cuts and birdsmouth without re-keying the pitch.
What are the limits?
- Decimal inches only. The inputs use the iPhone decimal pad, not the feet-inch-fraction keypad. Key 13-7/8” as 13.875. The pill changes how results display, not how inputs are read.
- The diagonal has to be the longest side. In Rise-Diagonal or Run-Diagonal mode, a diagonal shorter than (or equal to) the other side doesn’t throw an error. The missing side comes back as 0, and pitch reads Plumb or 0:12. If you see that, you swapped the numbers.
- Pitch is rounded to one decimal. For finer slope, read the Angle row (0.01°) or Grade (0.1%).
- The angle is the base angle. The angle at the top of the triangle is 90° minus it.
- Lengths display to 1/16” in ft-in and in formats, and to three decimals in the decimal formats.
App or web?
The web roof pitch calculator does the same rise, run and angle conversions in a browser, which is fine for estimating from plans at a desk. On a roof with no signal, the app works offline and hands the result straight to Rafters.